Benjie Ko <gerwalk1@yahoo.com> writes:
> now that is resolved, my client has a t3 card also
> with coax interface. Is it possible to cross connect
> both routers (coax to coax) w/o the use of a fiber
> DSU? Routers are 20 feet apart.
> Thanks again in advance.
Yes, it works great (Tx on one end to Rx on the other). One end
should be supplying clocking, and the other should be recovering
clocking from the line.
Makita#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Makita(config)#int serial 4/0
Makita(config-if)#clock source ?
internal Use internal clock
line Recover clock from line
Makita(config-if)#clock source
---Rob
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:42 EDT