A few years(jobs) ago, we had a pop in a building where the dacs was
so far away that the pa-t3/pa-2t3 would not supply sufficent power
all the time and we'd see circuit errors periodically.
we did not see the problem with other hardware including a
BPX15 and DL Ext CSU. I wouldn't use the pa-t3 if you're not within about
100m [cable distance] of the equipment. Someone can speak up if the
recent hardware doesn't have this problem. just my experience..
the equipment was a few floors away in a tall building....
- Jared
On Thu, Apr 25, 2002 at 08:56:34PM -0400, jlewis@lewis.org wrote:
> I've had trouble doing this on some occasions, supposedly due to cables
> being too short and too much signal strength. Also, it seems some
> PA-2T3's are more sensitive to this than others.
>
> On 25 Apr 2002, Robert E. Seastrom wrote:
>
> >
> > Benjie Ko <gerwalk1@yahoo.com> writes:
> >
> > > now that is resolved, my client has a t3 card also
> > > with coax interface. Is it possible to cross connect
> > > both routers (coax to coax) w/o the use of a fiber
> > > DSU? Routers are 20 feet apart.
> > > Thanks again in advance.
> >
> > Yes, it works great (Tx on one end to Rx on the other). One end
> > should be supplying clocking, and the other should be recovering
> > clocking from the line.
> >
> > Makita#conf t
> > Enter configuration commands, one per line. End with CNTL/Z.
> > Makita(config)#int serial 4/0
> > Makita(config-if)#clock source ?
> > internal Use internal clock
> > line Recover clock from line
> >
> > Makita(config-if)#clock source
> >
> > ---Rob
> >
>
> --
> ----------------------------------------------------------------------
> Jon Lewis *jlewis@lewis.org*| I route
> System Administrator | therefore you are
> Atlantic Net |
> _________ http://www.lewis.org/~jlewis/pgp for PGP public key_________
-- Jared Mauch | pgp key available via finger from jared@puck.nether.net clue++; | http://puck.nether.net/~jared/ My statements are only mine.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:42 EDT