On Mon, May 20, 2002 at 09:38:38AM -0500, Stephen Sprunk wrote:
>
> Assuming you have dCEF on, traffic between two PAs on the same VIP does not
> go via MEMD or cross the CyBus at all. Without dCEF, you're more likely to
> kill the RSP before the CyBus.
dCEF is on of course, but there is a caveat: traffic between two POS OC3
PA's, even if they are on the same VIP, does go through MEMD.
> Also, realize each side of the 7576 has two CyBuses:
I do. ;)
> Moving some cards around may lower your load.
At this point in time things look like thhat there is double-counting
somewhere. Either that, or my 7500's somehow flipped into cxbus mode.
*sigh*.
The point of my investigation is to find out why my sy0bus is reporting
unreasonable high load (no traffic passing through the router does add up to
the reported ~80% utilization (it's rather closer to 40%), unless double
counting is happening).
SY,
-- CCNP, CCDP (R&S) Dmitri E. Kalintsev CDPlayer@irc Network Architect @ connect.com.au dek @ connect.com.au phone: +61 3 9674 3913 fax: 9251 3666 http://-UNAVAIL- UIN:7150410 cell: +61 414 821 382
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:44 EDT