You do know that you create sub-interfaces and that the encap goes
on the sub-interface, not the main one? It's not obvious until
you've been there.
It definitely works on 12.0.[78]S on PA-FE's, though be careful
about deleting sub-interfaces if you're using *CEF...
George
> From: Michael Beckmann <petzi@apfel.de>
> To: cisco-nsp@puck.nether.net
> Subject: [nsp] Routing between VLANs using 802.1q
>
> I want to route between VLANs on a Cat4003 switch. The switch
> only supports 802.1q. The router is a 7513 with PA-GE (I could
> get a GEIP if that helped).
>
> The Gigabit Ethernet interfaces for the 7513 are supposed to
> support 802.1q, but I cannot find a way of configuring it. I
> am using 12.0(7)T, and there is no "encapsulation" command for
> the GigabitEthernet interface.
>
> Has anybody done this before ? I would appreciate your comments.
>
> I even found a bug ID (CSCdm75730) for this in the 12.0(7)T
> caveats, so it must be possible :-)
>
> Michael
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:09 EDT