Actually there is a problem. The problem is with the ACL that is being used
to select the route to send. The ACL shown selects a host route to 0.0.0.0
(0.0.0.0/32).
You would probably be better off with a prefix list like:
ip prefix-list default seq 5 permit 0.0.0.0/0
route-map default-map permit 10
match ip address prefix-list default
David
-----Original Message-----
From: George Robbins [mailto:grr@shandakor.tharsis.com]
Sent: Thursday, January 04, 2001 9:52 AM
To: cisco-nsp@puck.nether.net; Insik_Park@infonet.com
Subject: Re: [nsp] BGP default-originate
You won't be able to see the default internally, it's part of the
output editing done when routes are actually sent to the neighbor.
Look at the received routes on the neighbor. It might be helpful
to set some community on the default route so that you can identify
it as the one you're originating. Also, note that changing the
route-map will only take effect if you clear the session...
George
> From cisco-nsp-request@puck.nether.net Thu Jan 4 12:34:12 2001
> Date: Thu, 4 Jan 2001 12:26:25 -0500
> X-From_: Insik_Park@infonet.com Thu Jan 4 12:26:25 2001
> Received-Date: Thu, 4 Jan 2001 12:26:24 -0500
> From: Insik_Park@infonet.com
> To: cisco-nsp@puck.nether.net
> Old-Date: Thu, 4 Jan 2001 09:26:20 -0800
> X-MIMETrack: Serialize by Router on LAXAPP/SVR/ISC(Release 5.0.5
|September 22, 2000) at
> 01/04/2001 09:27:09 AM
> Old-X-Envelope-To: cisco-nsp
> Resent-From: jared@puck.nether.net
> Resent-Date: Thu, 4 Jan 2001 12:31:45 -0500
> Resent-To: cisco-nsp@puck.nether.net
> Subject: [nsp] BGP default-originate
> X-Mailing-List: <cisco-nsp@puck.nether.net> archive/latest/4733
> X-Loop: cisco-nsp@puck.nether.net
> Precedence: list
> Resent-Sender: cisco-nsp-request@puck.nether.net
>
> Hello all,
>
> I am trying to inject default route 0.0.0.0 to eBGP neighbor using
> default-originate and route map, but it doesn't seem to work. Below is
the
> configuration. Am I missing something? If I use default-originate
without
> route-map, then it successfully injects default network to eBGP neighbor.
>
> !
> router bgp 200
> neighbor 200.100.1.2 remote-as 400
> neighbor 200.100.1.2 default-originate route-map default-map
> !
> route-map default-map permit 10
> match ip address 1
> !
> access-list 1 permit 0.0.0.0
> !
> ip route 0.0.0.0 0.0.0.0 195.190.1.1
>
> ------------------
> !
> router bgp 400
> neighbor 200.100.1.1 remote-as 200
>
>
>
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:24 EDT