[nsp] back to back

From: Luan M Nguyen (lmnguyen@UU.NET)
Date: Wed Feb 21 2001 - 15:52:36 EST

Next message: Greene, Patrick: "[nsp] Traffic Simulators......."
Previous message: dhudson: "Re: NAT not using all IP NAT"
In reply to: jmaiman@ebnetworks.com: "Re: NAT not using all IP NAT"
Next in thread: Luan M Nguyen: "Re: NAT not using all IP NAT"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Hi Group,
Anyone know or tried to connect a 56k module to a t1 module before? with
integrate csu/dsu.
i know that the connector for t1 is rj-48c with 1,2,4,5 wire and for 56k is
1,2,7,8 rj-48s and it can use the console cable for backtoback
but how does one go about to cross connect between 56k and t1?

Another one is how to back-to-back between a DS3 serial and a channelize
DS3 ? is there way?
and how about 2 channelize DS3 ? just chanelize into a couple of T1 or so
under controller T3 and those T1 interface would pop up/up?
Thx in advance.

Regards,

LMN

Next message: Greene, Patrick: "[nsp] Traffic Simulators......."
Previous message: dhudson: "Re: NAT not using all IP NAT"
In reply to: jmaiman@ebnetworks.com: "Re: NAT not using all IP NAT"
Next in thread: Luan M Nguyen: "Re: NAT not using all IP NAT"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:30 EDT