[nsp] REG: Cisco 7206-VXR with NPE 300

• Next message: Martin Cooper: "[nsp] CCIE Communications & Services"
• Previous message: Eric Osborne: "Re: [nsp] CR-LDP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Dear All,

On a Cisco 7206-VXR with an NPE 300M with IOS Version 12.1(6) "Enterprise
featureset". I do have a Channelized E1 card (PA-MC-8E1). Now I am trying
to give a remote loop on the line (E1) to which its connected, & the only
two commands I see under the "Controller E1 " interface configuration are
-

1. loopback local <diag / line>
2. loopback diag

Further the E1 port is configured as a single bundle consisting of
timeslots 1-31. Is there any way by which a remote loop can be issued. I
am unable to also find any loopback statements under the "Serial"
interface configuration which gets automatically created while configuring
the E1 ports.

Kindly enlighten me.

With warm regards,

Vinod.

• Next message: Martin Cooper: "[nsp] CCIE Communications & Services"
• Previous message: Eric Osborne: "Re: [nsp] CR-LDP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:30 EDT