Hello,
I would like to enable vpdn in my 3640 router, but it doesn't work, can any
one tell me what should i do ?
Best regards
N.B: there is the "show version"
3640#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3640-I-M), Version 12.0(7)T, RELEASE SOFTWARE
(fc2)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Wed 08-Dec-99 01:46 by phanguye
Image text-base: 0x600088F0, data-base: 0x60856000
ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
3640 uptime is 23 hours, 47 minutes
System returned to ROM by reload
System image file is "flash:c3640-i-mz.120-7.T"
cisco 3640 (R4700) processor (revision 0x00) with 36864K/12288K bytes of
memory.
Processor board ID 22105993
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Channelized E1, Version 1.0.
MICA-6DM Firmware: CP ver 2310 - 6/3/1998, SP ver 2310 - 6/3/1998.
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
31 Serial network interface(s)
8 Low-speed serial(sync/async) network interface(s)
60 terminal line(s)
2 Channelized E1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
3640#conf t
Enter configuration commands, one per line. End with CNTL/Z.
3640(config)#vpdn ?
% Unrecognized command
3640(config)#
Mounir AZIZI
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:34 EDT