Hello,
I want to know when peak value of 'frame-relay traffic-rate' command works.
I am going to utilize 2Mbps Frame Relay access-line as,
CIR = 500Kbps
EIR = 2Mbps
If I use following map-class, it pass through only 500Kbps traffic,
even though 2Mbps was set as peak value. What should I do?
map-class frame-relay fast_vc
frame-relay traffic-rate 500000 2000000
frame-relay adaptive-shaping becn
'show traffic-shaping' is saying like this.
Interface Se0.1
Access Target Byte Sustain Excess Interval Increment
Adapt
VC List Rate Limit bits/int bits/int (ms) (bytes)
Active
30 500000 195312 500000 1500000 125 7813 BECN
I tried other way of configuration like this.
map-class frame-relay fast_vc
frame-relay adaptive-shaping becn
frame-relay cir 2000000
frame-relay bc 500000
frame-relay be 1500000
frame-relay mincir 500000
In this case, traffic goes through at around 2Mbps, and if there is another
PVC with similar map-class, it shares bandwidth suitably.
Please give me suggestion if I am doing correct or not.
Thanks.
-----
Kouji Baba
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:48 EDT