Won't do anything, you need to use some kind of rate-limiting/traffic-shaping
on the interface. The "bandwidth" is just a declaration available to the
routing protocols.
mrtg and possibily other measuring/management systems may take it was the
maximum bandwidth, mrtg in particular will make nice flat-topped graphs
because it belives any meansures > bandwidth must be bogus and it just
carries over the last "valid" value. 8-)
George
> From: "Dave VanAuken" <dave@hawk-systems.com>
> To: <cisco-nsp@puck.nether.net>
> Date: Sun, 14 Oct 2001 20:55:23 -0400
> Subject: [nsp] throttle BW on one port of Catalyst 3524XL
> Resent-From: cisco-nsp@puck.nether.net
> X-Mailing-List: <cisco-nsp@puck.nether.net> archive/latest/7849
>
> Have an NT box going on our network, wish to throttle the FastEthernet port that
> it is on to 1mb max. Have set "bandwidth 1000" in the interface config... can
> I assume that is sufficient to allow it a maximum of 1mb bi-directional
> bandwidth?
>
> thx
>
> Dave
>
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:51 EDT