I would load some different software.
I suggest c7200-p-mz.120-19.S
Or something newer than that and with -k4p- if you
have access to that out of the service provider branch.
That should support your board correctly.
If you are truly daring you could also run 12.2(4)T1
which also has ipv6 as well as most new hardware/feature support.
- Jared
On Tue, Dec 11, 2001 at 10:59:29AM -0600, Marius Strom wrote:
> Folks,
> Dealing with a brand-new out of the box 7204VXR with a c7200I/O-2FE/E
> board. The bootstrap recognizes the FE ports (12.1.8a-kboot), but
> putting a "normal" IOS image (tried with c7200-12.1-12-is56i-mz.bin) does
> not see the interfaces, and proceeds to give errors about environment
> monitoring (voltage levels, etc.). `show diag` gives a message about
> unknown Port Adapter type 533 in slot0, which is in fact the slot with
> the c7200I/O-2FE/E.
>
> The serial card (DS3 card) is detected in slot1 in kboot and normal
> image.
>
> None of these error messages appear while the router is in the kboot
> image, so I'm assuming it's not a hardware issue. The VXR has 128M DRAM
> so it's not a memory issue as well.
>
> Glancing back at various Cisco Press books point me nowhere, nor does
> google. Any ideas? If more info is needed, feel free to flame me and
> ask for more info and I'll provide what I can.
>
> --
> /------------------------------------------------->
> Marius Strom | Always carry a short length of fibre-optic cable.
> Professional Geek | If you get lost, then you can drop it on the
> System/Network Admin | ground, wait 10 minutes, and ask the backhoe
> http://www.marius.org/ | operator how to get back to civilization.
> \-------------| Alan Frame |---------------------->
-- Jared Mauch | pgp key available via finger from jared@puck.nether.net clue++; | http://puck.nether.net/~jared/ My statements are only mine.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:12:57 EDT