could you send us the config you are using?
Thanks,
Adi
On Fri, Feb 22, 2002 at 03:58:02PM -0600, Mehta, Phoram wrote:
>
> i have two subnets 10.10.6.0 and 10.10.3.0 connected on e0 and e1 of a Cisco
> 2600 respectively. there are no access lists applied on any of them. but i
> can't ping between each other. i get request timed out.
>
> any ideas?
>
>
> Phoram Mehta
> Trabon Solutions
> Network Engineer
> Email:pmehta@trabonsolutions.com <mailto:Email:pmehta@trabonsolutions.com>
> Tel: (816) 276 2500 ext: 519
>
>
> -----Original Message-----
> From: Jesper Skriver [mailto:jesper@skriver.dk]
> Sent: Friday, February 22, 2002 3:18 PM
> To: cisco-nsp@puck.nether.net; Stephen Sprunk; Gyorfy, Shawn
> Subject: Re: [nsp] Cisco DS3 Questions..
>
>
> On Fri, Feb 22, 2002 at 09:16:08PM +0100, Niels Bakker wrote:
> > * jesper@skriver.dk (Jesper Skriver) [Fri 22 Feb 2002, 20:53 CET]:
> > > We allways use PPP, the primary reasons being:
> > >
> > > - The line protocol goes down when the line is looped.
> >
> > Is that dependent on encapsulation used? I don't think so:
> >
> > !
> > interface Serial0
> > down-when-looped
> > !
> >
> > is the magic command, if I recall correctly.
>
> Yes, when doing HDLC, PPP will newer come up on a looped line.
>
> And as I said before, it's not default in HDLC, so it's like not to be
> configured on a CPE device.
>
> > > - It's easier to debug than HDLC
> >
> > In what respect? I've had less need for debugging circuits with HDLC
> > than with PPP due to authentication templates I talked about before,
> > and the physical interface counters are the same.
>
> debug ppp neg
>
> is a lot easier for me to read than
>
> debug serial interface
>
> It could be that I'm more used to it, but all the I've seen you've seen
> etc is really annoying, at least I think.
>
> /Jesper
>
> --
> Jesper Skriver, jesper(at)skriver(dot)dk - CCIE #5456
> Work: Network manager @ AS3292 (Tele Danmark DataNetworks)
> Private: FreeBSD committer @ AS2109 (A much smaller network ;-)
>
> One Unix to rule them all, One Resolver to find them,
> One IP to bring them all and in the zone to bind them.
>
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:05 EDT