On Thu, Mar 14, 2002 at 10:06:33AM +0100, Blaz Zupan wrote:
> > If for some reason .q1 can't be used (it requires VLAN capable switch),
> > you can try with NM-2W and two WIC-1ENET (actualy 2600 can have up
> > to 6 Ethernet ports; 2x Fe fixed, 2x WIC-1ENET in WIC slots, and
> > 2x WIC-1ENET in NM-2W).
>
> AFAIK, WIC-1ENET is only usable in 1700 series routers.
I'm not sure if this is still valid. It seems that with some 12.2
images 2600/3600 support ENET (or maybe it is just press error),
from <URL:http://www.cisco.com/univercd/cc/td/doc/product/software/
ios122/122relnt/1700/rn1700xj.htm> (mind the wrap):
The Cisco 1720 router supports any combination of one or two of the
following WAN interface cards, which are shared with the Cisco 1600,
2600, and 3600 routers:
- WIC-1T?One port high speed serial (sync/async)
- WIC-2T?Two port high speed serial (sync/async)
- WIC-2A/S?Two port low speed serial (sync/async) (up to 128 kbps)
- WIC-1B-S/T?One port ISDN BRI S/T
- WIC-1B-U?One port ISDN BRI U
- WIC-1DSU-56K4?One port integrated 56/64 kbps 4-wire DSU/CSU
- WIC-1DSU-T1?One port integrated T1 / Fractional T1 DSU/CSU
- WIC-1ENET?One-port 10Base-T Ethernet interface <<<<<<<< watch this....
- WIC-ADSL--One-port asymmetrical digital subscriber line (supported on
the 1700, 2600, and 3600 routers only)
If this is error then only NM-4E (4x Eth) works as solution.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:08 EDT