RE: [nsp] OSPF

From: Scott.Keoseyan@BroadWing.com
Date: Fri Mar 15 2002 - 22:03:08 EST


Check your version... sounds like you booted off a boot image instead of an
operational version of IOS.

Scott

-----Original Message-----
From: Dhiman Barman [mailto:dhiman@cs.bu.edu]
Sent: Friday, March 15, 2002 7:33 AM
To: cisco-nsp@puck.nether.net
Subject: [nsp] OSPF

Hi,
  I am using RSP-7000 and RP-7000 series routers to set up ospf
routing. I can configure ospf in RP-7000 routers but in RSP-7000,
there seems to be no options for protocols and ospf. Do I need to do
anything as the following commands are found.

  show ip protocols
  show ip ospf

I had rebooted the routers and started from beginning.

Thanks,
Dhiman

-- 
Necessity is a mother.
 +++The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material.  Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited.   If you received
this in error, please contact the sender and destroy any copies of this
document.+++



This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:08 EDT