Hello. I hope this is the right list, if not let me know and I'll refrain
from posting similar messages again. Thanks. :)
I'm having a problem with a Cisco 2524 w/ the Integrated NT1 BRI Card. For
some reason it is not seeing the SPIDs for the ISDN circuit connected to
it. The SPIDs are set correctly in the interface, and this has been
confirmed with telco and Cisco.
Telco sees the line "in service" but does not see equipment attached to it
past the NT1. The Cisco does not see the SPIDs. This is connected to a
5eSS switch and is configured as such.
Unfortunetly I don't have the configuration in front of me, as I am at
home, but any advice you can offer would be appreciated.
Keith
==========================================================================
Keith M. McCallion Director; Network Operations
Trippin on irc.iswest.net Internet Specialties West
keith@iswest.net/keith@hick.com 31194 La Baya Dr, Ste 100
P: 818-735-3000, F: 818-735-3004 Westlake Village, Calif. 91362
==========================================================================
Please take note: My Extension has changed from 104 to 107
==========================================================================
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:14 EDT