I am relatively new with this, so, I configured router in accordance with
sample configuration for AS5200 and, when I started to set up analog call to
it I receive the following:
ISDN Se2/0:15: RX <- SETUP pd = 8 callref = 0x000A
Sending Complete
Bearer Capability i = 0x8090A3
Channel ID i = 0xA98385
ISDN Se2/0:15: Incoming call id = 0xA
ISDN Se2/0:15: received CALL_INCOMING
ISDN Se2/0:15: Event: Received a Voice call from <unknown> on B5 at 64 Kb/s
ISDN Se2/0:15: CALL_INCOMING: MODEM ERROR 2C: bchan 4, call id A
leaving CCPRI_ReleaseCall, Allocated CCBs = 4
ISDN Se2/0:15: entering process_rxstate, CALL_CLEARED
ISDN Se2/0:15: TX -> RELEASE_COMP pd = 8 callref = 0x800A
Cause i = 0x80AC - Requested channel not available
>
Could anyone point me to proper knob I need to turn? ;)
interface Serial2/0:15
no ip address
encapsulation ppp
no ip mroute-cache
isdn incoming-voice modem
dialer pool-member 7 max-link 1
dialer pool-member 8 max-link 2
dialer pool-member 2 max-link 1
dialer pool-member 3 max-link 1
dialer pool-member 4 max-link 1
dialer pool-member 5 max-link 2
dialer pool-member 6 max-link 1
dialer pool-member 254 max-link 2
dialer pool-member 9 max-link 1
no fair-queue
no cdp enable
ppp authentication chap callin
ppp chap hostname <....>
ppp multilink
!
interface Group-Async1
ip unnumbered Ethernet0/0
ip tcp header-compression passive
encapsulation ppp
async dynamic address
async mode interactive
peer default ip address pool setup_pool
no cdp enable
ppp authentication chap pap
group-range 33 62
line 33 62
autoselect during-login
autoselect ppp
transport input all
flowcontrol hardware
line aux 0
line vty 0 4
password <...>
length 25
!
--------------------------------------
Basil (Vasily) Dolmatov dol@east.ru +7-095-956-4951
East Connection ISP, Moscow, Russia. (http://www.east.ru)
Nick handles ;) : BVD12, DOL1-RIPE, VVD2-RIPN
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:15 EDT