You have to configure the router for EIGRP. I have many 2501's and smaller
routers such as 1005's running EIGRP. In the config, enter these commands
router eigrp (internal AS)
redistribute static (this will redestribute your static routes into your
eigrp network)
redistribute connected (same as above, except this time will use the
devices that are "connected")
network x.x.x.x (this needs to be the /24 that the serial interfaces on
this router are on, ie, your serial interfaces are 10.10.10.23 and
10.10.10.56, then you would need network 10.10.10.0)
and that's it, all routers connected to this router, and have their eigrp
configed right, will start learning routes...
eigrp is very easy and effective...
luke
At 11:17 AM 3/23/98 -0500, Mike Gibbs wrote:
>I have a question. O am trying to get eigrp to work on a 2509 and, the
>process seems to show up, but its never in the configs, and the rest of
>the network fails to see it. Is this function turned off for the smaller
>routers?
>
>Mike Gibbs
>ServInt Corp
>
>
>
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* Luke Parrish * Email ciscokid@iamerica.net *
* LDS-iAmerica, ISP * Pager 1-800-789-6062 x3910 *
* Network Engineer * Phone 1-800-789-6062 x3010 *
* AS 4958 ICQ 3606426 * http://cust.iamerica.net/lparrish *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* I love the Internet, and you should too. *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:15 EDT