Perhaps I can bother you with a basic NAT question?
I have an 802 ISDN router set up with a static dial-in IP. We're
looking to open all ports on the router to pass through to an internal
IP (except telnet). So I used the following commands:
ip nat translation timeout 1800
ip nat inside source list 1 interface Dialer1 overload
ip nat inside source static 172.17.253.2 209.101.148.208
where 209.101.148.208 is the statically assigned IP address (by ISP).
Everything works well, except I can not telnet into the router via the
world side. I am quite sure that in the past I have done the same thing
and had no problems. Perhaps the IOS does something differently? Any
advice?
Thank you very much,
Ken Reiss.
--************************* Kenneth A. Reiss Port One Internet, Inc. 160 Chapel Road Manchester, CT 06040 860-722-3000 860-533-0033 Fax: 533-7225 *************************
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:19 EDT