Hi David,
No, it is not an external LSA.
I am going to raise a call to Cisco as I think the issue maybe related to
IOS. One of our customers
on a previous version of IOS has the correct entries as I would expect to
see in the routing table and OSPF
database.
My simple test network pretty much follows the customers network anyway.
Thanks for your input though.
regards, Ian
email: ijt@evasam.com
-----Original Message-----
From: David Bergum [mailto:bergum@cisco.com]
Sent: 04 October 2001 17:23
To: Ian Terry
Cc: cisco-nsp@puck.nether.net
Subject: Re: [nsp] OSPF Database question
>>>>> On Thu, 4 Oct 2001 15:55:26 +0100, "Ian Terry" <ijt@evasam.com> said:
Ian> Hi,
Ian> I have a question regarding the OSPF database output from a "show ip
ospf
Ian> database". In my test environment, I have a router with equally
costed
Ian> routes to a destination and these can be seen from issuing a "show ip
Ian> route". An extended PING will also demonstrate that load-balancing is
Ian> occuring.
Ian> When I look at the OSPF database "show ip ospf database", I do not
see both
Ian> references to the destination, I only see one reference. Should I not
see
Ian> both references to the destination??
Depends on your topology. What do you mean by destination? Is this an
external lsa?
OSPF is a link state protocol. If you have an adjacency to a neighbor over
two equal cost paths, and that neighbor is advertising an external lsa,
there may well only be one lsa in the link state database, but two paths to
the router advertising that link state.
Dave.
This archive was generated by hypermail 2b29 : Sun Aug 04 2002 - 04:13:19 EDT