One of the addresses will be the primary for the interface. I think
this is the one to be used. You can choose which address becomes the
primary in the config. By default it's probably the first one that was
configured.
Dave Humphrey
-----Original Message-----
From: Ben Buxton [mailto:b.buxton@planettechnologies.nl]
Sent: 29 May 2002 15:47
To: 'juniper-nsp@puck.nether.net'
Subject: [j-nsp] Question on default-address-selection
The JUNOS documentation says that using this command causes all
locally originated traffic to use the lo0 address as the
source address. However, what happens if there is more than
one IP address configured on lo0?
Thanks,
BB
This archive was generated by hypermail 2b29 : Mon Aug 05 2002 - 10:42:36 EDT