[j-nsp] AW: [j-nsp] question on as loop

From: Strahler, Carsten (Carsten.Strahler@lambdanet.net)
Date: Mon Feb 11 2002 - 02:41:02 EST

Next message: Kisito Nguene Ndoum: "Re: [j-nsp] question on as loop"
Previous message: Martin, Christian: "RE: [j-nsp] questions on cli"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Hi Dave,

did you consider the using of the command as-override ? It should match your
requirements.

regards

------------------------------------------------------------
Carsten Strahler

IP Planning

Lambdanet Communications GmbH (AS 13237)
Guenther-Wagner-Allee 13
D-30177 Hannover (Germany)

Phone +49 (0)511 / 84 88 - 12 86
Fax +49 (0)511 / 84 88 - 12 59
mailto:carsten.strahler@lambdanet.net

web: www.lambdanet.net
-----------------------------------------------------------

> -----Ursprüngliche Nachricht-----
> Von: Dave Qi [mailto:dqi@bloomberg.com]
> Gesendet: Montag, 11. Februar 2002 02:23
> An: juniper-nsp@puck.nether.net
> Betreff: [j-nsp] question on as loop
>
>
> "autonomous-system # loops x" command applies to all bgp
> peering sessions.
> is there any command that allows loops on a per peering session basis?
> for example, if you have a l3vpn routing-instance on hub-pe
> router that
> loops, but all other inet.0 bgp peering session is loop free,
> can you just
> apply this command under the routing-instance vpn session instead?
>

Next message: Kisito Nguene Ndoum: "Re: [j-nsp] question on as loop"
Previous message: Martin, Christian: "RE: [j-nsp] questions on cli"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Mon Aug 05 2002 - 10:42:39 EDT