DX100B Restoration

[Brian Carling]

Yes I will try another 6AU6 first.
The main issue is chirp on CW, and that might be easier to fix with 
grid-block keying or letting the VFO run all the time during transmit.
Or perhaps both. It will be an interesting project.

On 3 Mar 2005 at 11:26, Garey Barrell wrote:

> Bry -
> 
> The DX-100 VFO is essentially the VF-1.   This VFO as designed is
> quite capable of chirp-free, drift-free (for it's era), operation.  
> Changing the VR tube voltage or regulating the plate voltage have
> little or no effect.  It is an Electron Coupled Oscillator, and the
> plate voltage has no effect on the oscillator, and very little on the
> loading.
> 
> Part of the drift problem is a result of the temperature variations in
> the DX-100, both warm-up (at least an hour because of the huge mass of
> metal), and from transmit to receive.  The latter is especially
> noticeable with AM "old buzzard" transmissions.
> 
> Solder, mounting hardware, and especially the bus wiring are all
> contributors (or detractors) of stability.  Make sure the bus wiring
> especially is well soldered and not "under tension" from
> point-to-point.  It also is a good idea to "exercise" the trimmer caps
> a little and verify the ground connection.  DON'T over tighten the
> mounting hardware, they will break!  A little liquid Deoxit on the
> switch contacts and tube pins ONLY.  DON'T spray anything all over
> everywhere.
> 
> Replacing the 2.2k 1/2W resistor in the grid circuit with a 1W helped,
> both with drift and minor instability, and probably a carbon film
> would be even better today.
> 
> The silver mica caps are reliable, but some have replaced them with
> Dur-Mica's.
> 
> A GOOD VR tube is essential, just because they glow doesn't mean they
> are stable.  Many "dither" a few volts.
> 
> Selection of a GOOD 6AU6A is also necessary.  There is a BIG
> difference from tube to tube, even "new" ones, especially with regard
> to chirp.
> 
> 73, Garey - K4OAH
> Atlanta
> 
> Drake C-Line Service Manual
> <http://hr99.home.mindspring.com/R-4C_Servicez/>
> 
> 
> 
> Brian Carling wrote:
> 
> >Say guys,
> >
> >I just got this DX100 and it is clean when using crystal control but
> >the VFO drifts and chirps really badly.
> >
> >I was thinking of dropping the voltage regulator from 150V to 105V.
> >Any thoughts on this?
> >
> >73 de AF4K, Bry
> >  
> >
> 
> -----------------------------------------------------------
> This list is a public service of the City of Tempe, Arizona
> -----------------------------------------------------------
> 
> Subscription control -
> http://www.tempe.gov/lists/control.asp?list=BOATANCHORS To post -
> BOATANCHORS at LISTSERV.TEMPE.GOV Archives -
> http://listserv.tempe.gov/archives/BOATANCHORS.html

-----------------------------------------------------------
This list is a public service of the City of Tempe, Arizona
-----------------------------------------------------------

Subscription control - http://www.tempe.gov/lists/control.asp?list=BOATANCHORS
To post - BOATANCHORS at LISTSERV.TEMPE.GOV
Archives - http://listserv.tempe.gov/archives/BOATANCHORS.html