[Boatanchors] H500 Transoceanic Puzzler

[digital-conjurers at roadrunner.com]

OK, folks, after several weeks of troubleshooting this thing, I'm throwing 
the door open for some help.  In 18 years of working on vintage sets, this 
one has the distinction of being one of the most unpleasant.  Done several 
TXO's, and this is the most refractory set ever.

Problem: incurable audio distortion and hum under AC power.  (Clue: When 
one unplugs the set the problem goes away for 1/2 second before the set 
shuts down; audio is clear for that instant.  Thought it might be a power 
supply issue, but...)

Standard solutions tried, all check out:

1. Standard recap, wax and paper as well as electrolytics.
2. Replaced any resistor 20% or greater out of tolerance.
3. Verified all voltages
4. Replaced "unknown" diode (previous tech's work) with standard 1N4004 
with appropriate dropping resistor
5.  Verified all wiring several times
6. All tubes thoroughly tested on a Hickok 539B
7. Disc caps checked
8. Isolation from ground of chassis-mounted power dropping resistor

(Interestingly enough, the schematic that came with the set lists a 1U5 for 
the det/amp, while the schematic on nostalgiaair.com lists a 1S5.  Probably 
has nothing to do with it, just different production runs.  The set has 
what's called for, a 1U5.)

About all I am left with is chasing some stray, "fails-only-under-load" 
component (like an AVC cap with some resistance in it that does not show up 
under static voltage test with cap checker), or, or...a bad NEW cap? 
(unlikely.)

Posted a mp3 recording of the audio, and also made a copy of the schematic 
that _came with the set_ at www.moonlightsys.com/misc if anyone wants to go 
up there and  have a peek/listen.

I'd be very interested in opinions!

Thanks to the group in advance,

Lin/KJ6EF