[cisco-bba] PPPoE Stability

[Mounir Mohamed]

Dear Robert,

The session recovery or session reconnect can be done from the customer
side, a lot of CPE's support somthing called auto or reconnect, a also you
can use CHAP as authecntication protocol instead of PAP because the CHAP
protocol check the authenticated node every 2 minutes so if you clear the
session the customer MUST reconnect again after 2M even if he doesn't reboot
the modem.

Best Regards,
Mounir Mohamed


On 5/5/06, Robert Reichel <rreichel at net-metrix.net> wrote:
>
>  We have Cisco 7200's aggregating PPPoE, Paradyne DSLAMs and Starbridge
> and Paradyne DSL Modems running in the field.  We are looking for a way to
> make this solution more fault resilient so that CPE's recover without a
> reboot when we need to clear the sessions on the routers.  Below is our
> pppoe config from the router.
>
>
>
> vpdn-group pppoe
>
>  accept-dialin
>
>   protocol pppoe
>
>   virtual-template 1
>
>  pppoe limit per-mac 20
>
>
>
> interface Virtual-Template1
>
>  description *** PPPOE Virtual Template ***
>
>  ip unnumbered GigabitEthernet0/1
>
>  ip access-group 177 in
>
>  ip access-group 177 out
>
>  no ip redirects
>
>  ip mtu 1492
>
>  no ip route-cache cef
>
>  ip mroute-cache
>
>  peer default ip address pool pppoe-pool1 pppoe-pool2 pppoe-pool3
> pppoe-pool4
>
>  ppp authentication pap
>
>
>
> Does anyone have any suggestions for changing any parameters to allow the
> CPE to recover on their own?
>
>
>
> Thanks.
>
>
>
> RR
>
> _______________________________________________
> cisco-bba mailing list
> cisco-bba at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-bba
>
>
>


--
Best Reagrds,
Mounir Mohamed
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-bba/attachments/20060507/6b8324c9/attachment.html