<div dir="ltr"><div>> PPPoA only can run over an ATM PVC. This works fine for an ATM setup,<br>> CPE talking out its ATM PVC to the DSLAM hooked up via ATM back to the<br>> ATM cloud and back down to your LNS/termination box. But it doesn't<br>
> work when you do things differently.</div>
<div> </div>
<div>My ISP connect to by PA-A6-OC3SMI, and it tell me an ATM PVC to every cutomer, so I can use PPPoA</div>
<div> </div>
<div>Now I think to start is most friendly use RFC1483, but I don't know if I could use routed or bridge....???</div>
<div> </div>
<div>in my country the most big telco use RFC1483 but I don't see never our side but only customer site and I configure connction using this:</div>
<div> </div>
<div>interface ATM0<br> no ip address<br> no atm ilmi-keepalive<br> dsl operating-mode auto <br>!<br>interface ATM0.1 point-to-point<br> bandwidth 2048<br> ip address XXX.XXX.XXX.XXX <a href="http://255.255.255.252">255.255.255.252</a><br>
pvc 8/35 <br> oam-pvc manage<br> oam retry 5 5 1<br> encapsulation aal5snap<br> !</div>
<div> </div>
<div>Now I would configure my customer with this example but I don't configure never other side..... can you send me some example ??</div>
<div>This is is RFC1483 routed or bridge ??</div>
<div> </div>
<div>Thank you</div>
<div> </div>
<div>Mat</div></div>