[cisco-nas] AS5350 ISDN Problems

Wed Feb 25 11:49:50 EST 2004

Sounds like a PPP or AAA problem.  I suggest you take a look
at the output of debug ppp err, etc.  Why are you using PAP?

Regards,
Helen

At 07:34 PM 2/25/2004 +0300, GLO wrote:
>I have a Cisco access server AS5350 with E1 modules; and I am experiencing a
>strange problem.
>Some dialup calls on the ISDN line connect but the users can't transmit data
>(can't even ping the assigned IP).
>Other users disconnect immediately after authentication.The strange thing is
>that other users work just fine!
>I have included my config below. Any ideas?
>
>Regards,
>
>GLO
>--------------
>
>version 12.1
>no service single-slot-reload-enable
>service timestamps debug uptime
>service timestamps log uptime
>service password-encryption
>!
>hostname -------.kenyaweb.com
>!
>no boot startup-test
>logging rate-limit console 10 except errors
>no logging console
>aaa new-model
>aaa authentication username-prompt login:
>aaa authentication login default local group radius
>aaa authentication login console local line
>aaa authentication ppp default if-needed local group radius
>aaa authorization network default group radius
>aaa accounting send stop-record authentication failure
>aaa accounting nested
>aaa accounting update newinfo
>aaa accounting exec default start-stop group radius
>aaa accounting commands 15 default start-stop group radius
>aaa accounting network default start-stop group radius
>aaa accounting connection default start-stop group radius
>enable secret 5 000000000000000
>enable password 7 00000000000000
>!
>username admin password 7 0000000000
>!
>!
>resource-pool disable
>syscon address 192.168.100.1 cisco
>syscon shelf-id 0
>!
>!
>!
>!
>voice-fastpath enable
>ip subnet-zero
>no ip source-route
>no ip finger
>ip name-server ---------------
>ip name-server ---------------
>!
>frame-relay switching
>isdn switch-type primary-net5
>call rsvp-sync
>modemcap entry next:MSC=AT&FS0=0S29=6S65=1024S66=1024
>!
>!
>!
>!
>!
>fax interface-type modem
>mta receive maximum-recipients 0
>!
>!
>!
>controller E1 3/0
>framing NO-CRC4
>pri-group timeslots 1-31
>!
>controller E1 3/1
>framing NO-CRC4
>channel-group 1 timeslots 1-31
>!
>controller E1 3/2
>framing NO-CRC4
>pri-group timeslots 1-31
>!
>controller E1 3/3
>!
>controller E1 3/4
>!
>controller E1 3/5
>!
>controller E1 3/6
>!
>controller E1 3/7
>framing NO-CRC4
>channel-group 17 timeslots 17
>channel-group 18 timeslots 18
>channel-group 19 timeslots 19
>!
>!
>interface Loopback0
>no ip address
>!
>interface Tunnel0
>ip address 213.150.98.50 255.255.255.252
>tunnel source 195.202.84.182
>tunnel destination 195.202.92.206
>!
>interface FastEthernet0/0
>ip address 213.150.100.1 255.255.255.0 secondary
>ip address 213.150.99.177 255.255.255.240 secondary
>ip address 194.201.253.23 255.255.255.0
>ip access-group 100 in
>ip access-group 100 out
>no ip redirects
>no ip proxy-arp
>no ip mroute-cache
>duplex full
>speed 100
>no cdp enable
>!
>--More--
>interface FastEthernet0/1
>no ip address
>shutdown
>duplex auto
>speed auto
>no cdp enable
>!
>interface Group-Async0
>no ip address
>no group-range
>!
>interface Group-Async1
>ip unnumbered FastEthernet0/0
>encapsulation ppp
>no ip route-cache
>no ip mroute-cache
>carrier-delay 5
>async mode dedicated
>peer default ip address pool mypool
>no fair-queue
>ppp max-bad-auth 5
>ppp authentication pap
>group-range 1/00 2/59
>!
>interface Dialer1
>ip unnumbered FastEthernet0/0
>encapsulation ppp
>dialer in-band
>dialer idle-timeout 100000
>dialer-group 1
>peer default ip address pool mypool
>no fair-queue
>no cdp enable
>ppp max-bad-auth 5
>ppp authentication pap
>!
>!
>ip local pool mypool 21.15.7.1 21.15.7.100
>ip classless
>ip route 0.0.0.0 0.0.0.0 1.2.2.1
>!
>dialer-list 1 protocol ip permit
>!
>snmp-server community Kx12 RO
>!
>radius-server host 21.2.2.5 auth-port 1945 acct-port 1946 non-standard
>radius-server retransmit 3
>radius-server timeout 60
>radius-server key 7 00000000000000
>radius-server vsa send accounting
>radius-server vsa send authentication
>!
>voice-port 3/0:D
>!
>voice-port 3/2:D
>!
>!
>line con 0
>transport input none
>line aux 0
>autoselect during-login
>autoselect ppp
>line vty 0 4
>password 7 0000000000
>autoselect ppp
>line vty 5 28
>line 1/00 1/59
>no flush-at-activation
>autoselect ppp
>modem Dialin
>modem autoconfigure type next
>autocommand ppp
>transport input all
>line 2/00 2/59
>no flush-at-activation
>autoselect ppp
>modem Dialin
>modem autoconfigure type next
>autocommand ppp
>transport input all
>!
>scheduler allocate 10000 400
>end
>----------------
>
>_______________________________________________
>cisco-nas mailing list
>cisco-nas at puck.nether.net
>https://puck.nether.net/mailman/listinfo/cisco-nas

Helen M. Robison (email: hrobison at cisco.com)
Voice Technical Marketing Engineer
Service Provider Solution Engineering (SPSE)
direct: (408) 526-8938

In the beginning all the world was America... [John Locke}

Time wastes too fast:  every letter I trace tells me with what
rapidity Life follows my pen: the days and hours of it ...
flying over our heads like light clouds of a windy day,
never to return more.... [Laurence Sterne]