[cisco-nas] Cisco 3660 decompress error

[Jim Lackey III]

I have a Cisco 3660 Enterprise route that I increased the memory to 256MB
and the flash to 40MB. I have downloaded the latest IOS
(c3660-jk9o3s-mz.123-10.bin). and when it is loading I get the following
error:

 

 

program load complete, entry point: 0x80008000, size: 0x161e168

Self decompressing the image :
#################################################

#########################

Error : Uncompression of the image failed.

invalid compressed data--format violated

 

Error : zip decompress failed

 

*** System received a Software forced crash ***

signal= 0x17, code= 0x7, context= 0x80020b00

PC = 0x800080d4, Cause = 0x20, Status Reg = 0x3041f003

 

System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1)

Copyright (c) 1999 by cisco Systems, Inc.

C3660 processor with 262144 Kbytes of main memory

Main memory is configured to 64 bit mode with parity disabled

 

PC = 0xbfc0da24, Cause = 0x2000, Status Reg = 0x3041f003

 

I have search to TAC web site and cannot seem to find anything that points
me to why this error is happening.

 

I can boot a smaller image with no problem  (c3660-i-mz.121-17.bin).

 

Show version comman :

Cisco Internetwork Operating System Software

IOS (tm) 3600 Software (C3660-I-M), Version 12.1(17), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Wed 04-Sep-02 00:28 by kellythw

Image text-base: 0x60008950, data-base: 0x6089A000

 

ROM: System Bootstrap, Version 12.0(6r)T, RELEASE SOFTWARE (fc1)

 

Catus-router3 uptime is 1 minute

System returned to ROM by reload

System image file is "slot1:c3660-i-mz.121-17.bin"

 

cisco c3660 (R527x) processor (revision C0) with 254976K/7168K bytes of
memory.

Processor board ID JAB042684GL

R527x CPU at 225Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache

Bridging software.

X.25 software, Version 3.0.0.

Primary Rate ISDN software, Version 1.1.

 

 

3660 Chassis type: ENTERPRISE

2 FastEthernet/IEEE 802.3 interface(s)

6 Serial network interface(s)

2 Channelized T1/PRI port(s)

DRAM configuration is 64 bits wide with parity disabled.

125K bytes of non-volatile configuration memory.

32768K bytes of processor board System flash (Read/Write)

8192K bytes of processor board PCMCIA Slot1 flash (Read/Write)

 

Configuration register is 0x1922

 

I did take out the 8MB flash memory module and left a 32MB flash memory in.

 

Just wanted to know if anybody has had this problem and if so what can I do
to correct it.

 

Regards,

 

Jim Lackey III

Catus Technologies LLC

800 W 5TH Ave.

Suite 204A

Naperville, IL 60563

(630) 527-8729 x102

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-nas/attachments/20041013/6b87633b/attachment.html