[cisco-nas] 7206 PPPoE NAS crashed

Wed Feb 1 21:40:50 EST 2006

Dear All,

I am using 7206, which has specs as describe on show version below:

pppoe_ras#sh version

Cisco IOS Software, 7200 Software (C7200-JS-M), Version 12.4(3), RELEASE
SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Compiled Fri 22-Jul-05 09:12 by hqluong

ROM: System Bootstrap, Version 12.1(20000710:044039) [nlaw-121E_npeb 117],
DEVELOPMENT SOFTWARE

BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(24)S5, EARLY DEPLOYMENT
RELEASE SOFTWARE (fc1)

pppoe_ras uptime is 16 hours, 59 minutes

System returned to ROM by reload at 09:49:37 UTC Wed Feb 1 2006

System image file is "disk0:c7200-js-mz.124-3.bin"

Cisco 7206 (NPE225) processor (revision A) with 245760K/16384K bytes of
memory.

Processor board ID 10860270

R527x CPU at 262MHz, Implementation 40, Rev 10.0, 2048KB L2 Cache

6 slot midplane, Version 1.3

Last reset from power-on

Number of Fast PAs = 3

Number of Fast+Medium PAs = 4

Total number of PA bandwidth points consumed = 620

Please refer to the following document "Cisco 7200 Series Port

Adaptor Hardware Configuration Guidelines" on CCO <www.cisco.com>,

for c7200 bandwidth points oversubscription/usage guidelines.

4 Ethernet interfaces

2 FastEthernet interfaces

2 Serial interfaces

125K bytes of NVRAM.

62976K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).

4096K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2102

I am using it as PPPoE NAS. It operated only for about 27 days, and then
crashed. The power is still on, but I cannot access to the box via console
or FastEthernet port. However, when I switch off the power and switch on
again, the box can operate normally. I am not sure what the source of the
problem is. Anyone has ideas about it? The following is router's
configuration:

Current configuration : 3469 bytes

!

version 12.4

service timestamps debug uptime

service timestamps log uptime

service password-encryption

!

hostname pppoe_ras

!

boot-start-marker

boot-end-marker

!

enable secret 5 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

enable password 7 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

!

aaa new-model

!

!

aaa authentication ppp polpppoe group radius local

aaa authorization network polpppoe group radius

aaa accounting exec polpppoe start-stop group radius

aaa accounting network polpppoe start-stop group radius

!

aaa session-id common

!

resource policy

!

ip subnet-zero

no ip source-route

!

!

ip cef

!

!

no ip bootp server

vpdn enable

!

async-bootp dns-server 203.137.130.1 203.137.130.2

!

!

!

!

!

!

!

!

!

!

!

!

username root password 7 xxxxxxxxxxxxxxxxxxxxxxxxxx

!

!

!

bba-group pppoe global

 virtual-template 11

 sessions auto cleanup

!

!

interface Loopback0

 ip address 203.137.140.1 255.255.252.0

!

interface FastEthernet0/0

 ip address 202.137.130.17 255.255.255.0

 no ip unreachables

 no ip proxy-arp

 no ip mroute-cache

 duplex full

!

interface Serial1/0

 no ip address

 shutdown

 dsu bandwidth 44210

 framing c-bit

 cablelength 10

 serial restart-delay 0

!

interface Serial1/1

 no ip address

 shutdown

 dsu bandwidth 44210

 framing c-bit

 cablelength 10

 serial restart-delay 0

!

interface FastEthernet2/0

 ip address 10.10.0.1 255.255.252.0

 ip access-group 101 in

 no ip unreachables

 no ip proxy-arp

 no ip mroute-cache

 duplex full

 pppoe enable

!

interface Ethernet4/0

 no ip address

 shutdown

 duplex half

!

interface Ethernet4/1

 no ip address

 shutdown

 duplex half

!

interface Ethernet4/2

 no ip address

 shutdown

 duplex half

!

interface Ethernet4/3

 no ip address

 shutdown

 duplex half

!

interface Virtual-Template11

 mtu 1492

 ip unnumbered Loopback0

 ip access-group 101 in

 no ip route-cache cef

 no ip route-cache

 peer default ip address pool dial-in

 ppp authentication pap chap polpppoe

 ppp authorization polpppoe

 ppp accounting polpppoe

!

ip local pool dial-in 202.137.140.2 202.137.143.254

ip classless

ip route 0.0.0.0 0.0.0.0 202.137.130.254

!

no ip http server

!

!

access-list 101 deny   tcp any any eq 69

access-list 101 deny   tcp any any eq sunrpc

access-list 101 deny   tcp any any range exec cmd

access-list 101 deny   tcp any any lt ftp-data

access-list 101 deny   udp any any eq sunrpc

access-list 101 deny   tcp any any eq 135

access-list 101 deny   udp any any eq 135

access-list 101 deny   tcp any any eq 137

access-list 101 deny   udp any any eq netbios-ns

access-list 101 deny   udp any any eq netbios-dgm

access-list 101 deny   tcp any any eq 139

access-list 101 deny   udp any any eq netbios-ss

access-list 101 deny   tcp any any eq 445

access-list 101 deny   udp any any eq 445

access-list 101 deny   udp any any eq echo

access-list 101 deny   udp any eq echo any

access-list 101 permit ip any any

snmp-server community hello_wbb RO

snmp-server enable traps tty

no cdp run

!

!

!

radius-server host 202.137.130.5 auth-port 1812 acct-port 1813

radius-server timeout 25

radius-server key 7 xxxxxxxxxxxx

radius-server vsa send accounting

radius-server vsa send authentication

!

control-plane

!

!

!

!

dial-peer cor custom

!

!

!

!

gatekeeper

 shutdown

!

!

line con 0

 stopbits 1

line aux 0

 stopbits 1

line vty 0 4

 transport input telnet

!

!

End

Your help will be much appreciated. 

Regards,

Souphonh

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-nas/attachments/20060201/54d3dca5/attachment-0001.html