[cisco-nas] ISDN PRI back-to-back - again
Nemec Ladislav
Ladislav.Nemec at anect.com
Wed Jan 31 07:15:09 EST 2007
Hello,
I want to test some dialer watch scenario, but I don't have ISDN switch.
So I used back-to-back PRI connection between two routers.
On dialing router I received:
*Mar 2 13:55:37.372: ISDN Se1/0:15 Q931: TX -> SETUP pd = 8 callref =
0x3DC8
Bearer Capability i = 0x8890
Standard = CCITT
Transer Capability = Unrestricted Digital
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA9839F
Exclusive, Channel 31
Called Party Number i = 0x81, '320'
Plan:ISDN, Type:Unknown
*Mar 2 13:55:37.388: ISDN Se1/0:15 Q931: RX <- CALL_PROC pd = 8
callref = 0xBDC8
Channel ID i = 0xA9839F
Exclusive, Channel 31
*Mar 2 13:55:37.392: ISDN Se1/0:15 Q931: RX <- CONNECT pd = 8 callref
= 0xBDC8
Channel ID i = 0xA9839F
Exclusive, Channel 31
*Mar 2 13:55:37.396: ISDN Se1/0:15 **ERROR**:
call_setup_ack_proceeding: NO HDLC available b channel 30 call id 0xBDC8
*Mar 2 13:55:37.400: ISDN **ERROR**: Module-CCPRI
Function-CCPCC_CallReleasing Error-Unknown event received in message
from L3 ono 1ebug isdn q931
*Mar 2 13:55:37.404: ISDN Se1/0:15 Q931: TX -> DISCONNECT pd = 8
callref = 0x3DC8
Cause i = 0x80A2 - No circuit/channel available
*Mar 2 13:55:37.412: ISDN Se1/0:15 Q931: RX <- RELEASE pd = 8 callref
= 0xBDC8
*Mar 2 13:55:37.420: ISDN Se1/0:15 Q931: TX -> RELEASE_COMP pd = 8
callref = 0x3DC8
*Mar 2 13:55:37.424: ISDN Se1/0:15 Q931: Applying typeplan for sw-type
0x12 is 0x0 0x1, Called num 320
I don't know, why dialing router is still disconnecting call, if
opposite router accept call. Cause is "No circuit/channel available",
but there is no more calls.
Laco Nemec.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-nas/attachments/20070131/d3a5b79a/attachment-0001.html
More information about the cisco-nas
mailing list