[nsp] Cisco 2600XM error message

[Gregor von Stangen]

Hello,

I suspect, you have a VIC-1MFT-E1 controller ? If so, get
a RMA from your distributor. We had the same issue on a
few controllers of this type.

Regards,

  Gregor

--
PIRONET NDH AG
Gregor von Stangen - Head of NOC
Theodor-Heuss-Str. 92-100 - 51149 Cologne - Germany
Tel.: +49 (0)2203 93530 0 - Fax: +49 (0)2203 93530 99
mailto:gvonstangen@pironet-ndh.com - http://www.pironet-ndh.com



> -----Original Message-----
> From: Oyundalai.N [mailto:oyundalai@mobicom.mn]
> Sent: Montag, 9. Dezember 2002 18:21
> To: cisco-nsp@puck.nether.net
> Subject: [nsp] Cisco 2600XM error message
> 
> 
> Hello Everyone,
> 
> I see following message every ten second on the new 2600XM 
> router interface
> is down all time.
> "CONTROLLER-2-FIRMWARE: Controller E1 0/0, firmware is not running"
> 
> IOS version - 12.2 (5) T
> 
> What is the reason?
> 
> Best regards.
> 
> Oyundalai.N
> 
> Mobicom.
> Mongolia.
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp@puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>