[nsp] 12.0(23)S1 vip2-50 PA-MC-2T3+ sh int

[Jared Mauch]

	Has anyone else noticed a problem in 12.0(23)S1
where a PA-MC-2T3+ in a vip2-50 will report correct information via
snmp but the "sh interface" information will not show any inbound
or outbound bitrate?

eg:
  MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, rely 255/255, load 1/255
  Encapsulation HDLC, crc 16, loopback not set
  Keepalive set (10 sec)
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 1/75, 0 drops, 0 flushes
  30 second input rate 0 bits/sec, 0 packets/sec
  30 second output rate 0 bits/sec, 0 packets/sec
  ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
     4098374 packets input, 2952189411 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     3931930 packets output, 619351522 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 output buffer failures, 0 output buffers swapped out


	I was wondering if anyone else had seen this and had a
bugid handy.

	- jared

-- 
Jared Mauch  | pgp key available via finger from jared@puck.nether.net
clue++;      | http://puck.nether.net/~jared/  My statements are only mine.