[nsp] Router startup

[Aaron Lynch]

Thank you everyone!

I had forgotten to set it back...



On 10/10/02 1:22 AM, Mark D. Nagel mashed the following keys :

> Sounds like you just forgot to reset the config-register to 0x2102 after you
> finished the recovery.  This can be done in rommon or after you boot -- just
> enable, conf t, config-register 0x2102, then reload (don't save changes!).
> 
> Mark
> 
> ----- Original Message -----
> From: "Aaron Lynch" <a.list@ninewire.com>
> To: <cisco-nsp@puck.nether.net>
> Sent: Wednesday, October 09, 2002 11:31 PM
> Subject: [nsp] Router startup
> 
> 
>> Hi All,
>> 
>> I recently had to do a password recovery of my Cisco 2600 router, and I
>> think I may have messed something up:
>> 
>> I setup the config, then 'wr mem' and then do
>> 'copy running-config startup-config'
>> 
>> t1 works
>> 
>> But; if I power cycle the router, the config is nuked. t1 doesn't work :)
>> 
>> Apparently the 2600 is not using 'startup-config' when it boots.
>> 
>> Can anybody tell me how to setup the boot parameters to use the
>> startup-config file?
>> 
>> _______________________________________________
>> cisco-nsp mailing list  real_name)s@puck.nether.net
>> http://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>> 
> 
>