[nsp] Setting caller ID on PRI

[Cisco Geek Rotation]

At 10:19 AM 4/10/2003 -0400, Jared Mauch wrote:
>On Wed, Apr 09, 2003 at 06:04:40PM -0600, Cisco Geek Rotation wrote:
> > Hi folks:
> >
> > Here's a PRI on a NM HDV WIC card in a 3660 that allows me to make/receive
> > voice calls:
> >
> > interface Serial6/0:23
> >  no ip address
> >  no logging event link-status
> >  isdn switch-type primary-ni
> >  isdn incoming-voice voice
> >  isdn calling-number xxx-xxx-xxxx
> >  no cdp enable
> >
> > I've been pulling these individual B-channel trunks off-hook with an FXS
> > card and phone attached to it and when calling people using this method 
> the
> > caller ID information doesn't show up on the recipient's phone.
> >
> > I've tried changing the isdn calling-number command and that doesn't seem
> > to configure the info.  The telco says they aren't blocking it, and they
> > think I'm supposed to be doing something to make the info appear.
> >
> > Anyone have any ideas for me?
>
>         I've never configured one of these, do you get any
>corresponding voice-port interfaces?
>
>         I've found that one needs to enable caller-id
>on interfaces.
>
>eg:
>
>voice-port 1/0/1
>  caller-id enable
>
>in another case i have here, (older fxo card, doesn't do caller-id)
>i need to do this to generate some caller-id for the port.
>
>voice-port 1/1/0
>  input gain 14
>  no comfort-noise
>  connection plar 267
>  description FXO 734-332-7947
>  station-id name inbound-3327947
>  station-id number 1900
>
>
>         - Jared



OK well based on that I tried this:

voice-port 6/0:23
  echo-cancel coverage 32
  no comfort-noise
  connection plar 0
  description Voice PRI
  station-id name MyCompanyName
  station-id number 900-000-0000

This didn't work though, still no caller ID info shows.

Chris