[nsp] Setting caller ID on PRI

[Rolands Truls]

Try to use latest ios e.g. 12.2(15)T, i've seen the similar behavior in some
old softwares

regards
rolands
> -----Original Message-----
> From: Cisco Geek Rotation [mailto:cisco at peakpeak.com]
> Sent: ceturtdiena, 2003. gada 10. aprili 18:31
> To: Jared Mauch
> Cc: cisco-nsp at puck.nether.net
> Subject: Re: [nsp] Setting caller ID on PRI
> 
> 
> At 10:19 AM 4/10/2003 -0400, Jared Mauch wrote:
> >On Wed, Apr 09, 2003 at 06:04:40PM -0600, Cisco Geek Rotation wrote:
> > > Hi folks:
> > >
> > > Here's a PRI on a NM HDV WIC card in a 3660 that allows 
> me to make/receive
> > > voice calls:
> > >
> > > interface Serial6/0:23
> > >  no ip address
> > >  no logging event link-status
> > >  isdn switch-type primary-ni
> > >  isdn incoming-voice voice
> > >  isdn calling-number xxx-xxx-xxxx
> > >  no cdp enable
> > >
> > > I've been pulling these individual B-channel trunks 
> off-hook with an FXS
> > > card and phone attached to it and when calling people 
> using this method 
> > the
> > > caller ID information doesn't show up on the recipient's phone.
> > >
> > > I've tried changing the isdn calling-number command and 
> that doesn't seem
> > > to configure the info.  The telco says they aren't 
> blocking it, and they
> > > think I'm supposed to be doing something to make the info appear.
> > >
> > > Anyone have any ideas for me?
> >
> >         I've never configured one of these, do you get any
> >corresponding voice-port interfaces?
> >
> >         I've found that one needs to enable caller-id
> >on interfaces.
> >
> >eg:
> >
> >voice-port 1/0/1
> >  caller-id enable
> >
> >in another case i have here, (older fxo card, doesn't do caller-id)
> >i need to do this to generate some caller-id for the port.
> >
> >voice-port 1/1/0
> >  input gain 14
> >  no comfort-noise
> >  connection plar 267
> >  description FXO 734-332-7947
> >  station-id name inbound-3327947
> >  station-id number 1900
> >
> >
> >         - Jared
> 
> 
> 
> OK well based on that I tried this:
> 
> voice-port 6/0:23
>   echo-cancel coverage 32
>   no comfort-noise
>   connection plar 0
>   description Voice PRI
>   station-id name MyCompanyName
>   station-id number 900-000-0000
> 
> This didn't work though, still no caller ID info shows.
> 
> Chris
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>