[nsp] RE: Semi Complex configuration (EoMPLS)

[Kevin]

As I was researching the MPLS thing and I'm getting confused between MPLS and 
tag-switching, because my 5500 RSM supports MPLS but there are'nt any "mpls" commands,
Just tag-switching commands, while my 7500 router has the mpls commands.
The cisco documentation is'nt very clear on the difference :)
Can anyone explain the difference?

Kevin,

-----Original Message-----
From: Mark Sibering [mailto:M.Sibering at nl.tiscali.com] 
Sent: Friday, August 22, 2003 5:03 AM
To: Kevin
Subject: RE: [nsp] Semi Complex configuration


Try EoMPLS. This may provide what you are looking for. Don't know about caveats though....

Mark

-----Original Message-----
From: Kevin [mailto:kevin at honeycomb.net]
Sent: woensdag 20 augustus 2003 23:47
To: cisco-nsp at puck.nether.net
Subject: [nsp] Semi Complex configuration


Is this even possible?

5500----------Router+------10Mb Ether(WAN)-----+Router----------Switch
    trunk Link      |------GRE Tunnel----------|	Trunk Link

Then the Tunnel and Ethernet interfaces on both ends would be bridged. The reason why I want to do this is to tunnel 802.11q or ISL over that 10mb wan ethernet. Because our providor does'nt support vlans over the link.

Is there a better way to do this?
I do have an RSM in the 5500.

Kevin,





_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/