[nsp] Gigastack trouble

Kristjan Thordarson kth at ok.is
Tue Jan 28 15:52:55 EST 2003



http://www.stuff.is/gigflapping.mp3






-----Original Message-----
From: odusseus [mailto:odusseus at voila.fr] 
Sent: 27. janúar 2003 15:09
To: cisco-nsp
Subject: [nsp] Gigastack trouble


Hi,

I have a stack of four Cisco switches 3524XL (IOS c3500XL-c3h2s-mz-120.5.1XW) connected through a GIGASTACK connection.

This week, and once every two days, I got the following log messages from one switche and it last dew seconds:

Jan 25 08:18:44: %LINK-3-UPDOWN: Interface GigabitEthernet0/2, changed state to down Jan 25 08:18:45: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/2, changed state to down Jan 25 08:18:46: %LINK-3-UPDOWN: Interface GigabitEthernet0/2, changed state to up Jan 25 08:18:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/2, changed state to up Jan 25 08:18:56: %LINK-3-UPDOWN: Interface GigabitEthernet0/2, changed state to down Jan 25 08:18:57: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/2, changed state to down Jan 25 08:18:57: %LINK-3-UPDOWN: Interface GigabitEthernet0/2, changed state to up Jan 25 08:18:58: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/2, changed state to up Jan 25 08:19:00: %RTD-1-LINK_FLAP: GigabitEthernet0/2 link down/up 5 times per min Jan 25 08:19:05: %RTD-1-LINK_FLAP: GigabitEthernet0/2 link down/up 5 times per min Jan 25 08:19:11: %GIGASTACK-1-NO_LOOP_DETECT: The link neighbor of link 2 of Gigastack GBIC in Gi0/2 did not respond to the loop detection request. If loop topology is deployed, make sure all switches in the stack are running the latest software.

On the three other switches, I see the same messages concernining the flapping LINK-3-UPDOWN and RTD-1-LINK_FLAP without the GIGASTACK-1-NO_LOOP_DETECT message.

If this is a hardware trouble, won't it simply break and not work at all?

The switches have been working fine during the last 10 months, and their config did not change: ! interface GigabitEthernet0/2  description TRUNK TO sw3,sw5 and sw6 (GIGASTACK)  switchport trunk allowed vlan 1,21-23,1002-1005  switchport mode trunk !

How could I figure out if this is a hardware trouble?

Thank you.

Christophe
------------------------------------------

Faites un voeu et puis Voila ! www.voila.fr 



_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/



More information about the cisco-nsp mailing list