[nsp] 12.0(25.4)S: OSPF areas are not displayed correctly in config

[Matti Saarinen]

"Oliver Boehmer (oboehmer)" <oboehmer at cisco.com> writes:

> Looks like you've hit CSCeb59253 (Area identifiers erased after
> upgrade to 25.4S). According to its release-note, you can workaround
> the problem by specifying the area id's in integer instead of IP
> address x.x.x.x notation.

     That's it. I couldn't find any mention about that bug. I tried
     reading the relaese notes I found and also tried searching with
     the bug navigator. I found no references to this bug (it seems
     that even with the bug ID I cannot check it via bug navigator).


> Any special reason to run 12.0(25.4)S? 

     Yes, the one that I didn't "see" that the 12.0(25)S1 was released
     even though I read the release notes :-) I checked the ftpeng and
     also the directory for the crypto images. The latest on both
     sites was (25.4)S. That's why I upgraded only to 12.0(25.4)S.


> You might want to consider using 12.0(25)S1 which has just been
> released..

     Now, the router is upgraded to 12.0(25)S1 and the OSPF config
     looks normal. Thanks.


-- 
- Matti -