[nsp] Cant load ios??

[Stephen J. Wilcox]

On Fri, 18 Jul 2003, Jared Mauch wrote:

> 	two things.
> 
> 	1) Upgrade your bootflash: image to one that has
> support for your PA in slot 1.

Actually, the minimum IOS to support the NPE225.256Mb is too large for the 
7206's bootflash, this is documented on the site but at times like this very 
annoying :/

> 	2) Looks like the image in the flash/disk is corrupt.

darn, it is.. you should work for cisco Jared.. I thougth I checked this but you 
made me double check and you're right!

Steve

> 
> 	- Jared
> 
> On Fri, Jul 18, 2003 at 05:26:32AM +0100, Stephen J. Wilcox wrote:
> > Hi,
> >  I've the following platform - 7206/NPE-225(256Mb)/PA-2FE/IO-FE
> > 
> > am trying to reload 12.2(14)S3 having previously used 12.2(12)a
> > 
> > and I'm getting:
> > 
> > System Bootstrap, Version 12.0(19991120:010612) [nlaw-conn_4xe_ECC 112], 
> > DEVELOPMENT SOFTWARE
> > Copyright (c) 1994-1999 by cisco Systems, Inc.
> > C7200 platform with 262144 Kbytes of main memory
> > 
> > Self decompressing the image : 
> > ################################################################################################################################################################################################################################################################################################################# 
> > [OK]
> > 
> > %PA-2-UNDEFPA: Undefined Port Adaptor type 548 in bay 1
> > %PA-3-DEACTIVATED: port adapter in bay [1] powered off.
> > %SYS-5-CONFIG: Configured from  by 
> > %SYS-4-CONFIG_NEWER: Configuration from version 12.2 may not be correctly 
> > understood
> > %SYS-5-CONFIG: Configured from  by 
> > %SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
> > 
> > *** Emulating mis-aligned load at 0x3040b8af
> >     PC = 0x80009b94 ... 
> > *** TLB (Load/Fetch) Exception ***
> > Access address = 0x3040b8af
> > PC = 0xbfc0af64, Cause = 0x8, Status Reg = 0x3040d003
> > 
> > monitor: command "boot" aborted due to exception
> > 
> > 
> > Why is the PA-2FE undefined and why wont it reload? NPE225/256 requires 
> > 12.1(8)EC and it was ok on 12.2(12)a. Why not 12.2(14)S3 which is presumably 
> > incorporating 12.2(12)a ?
> > 
> > I've the time it takes to upload the original image to backout via console to 
> > work out if I'm to get this router upgraded tonight...
> > 
> > TIA
> > 
> > Steve
> > 
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > http://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/
> 
>