[nsp] Serial0/0:0 is reset, line protocol is down.... ?

[Bulger, Tim]

Ugh, never mind... The telco left a loop plug in.. 

-----Original Message-----
From: Bulger, Tim 
Sent: Friday, June 27, 2003 3:17 PM
To: cisco-nsp at puck.nether.net
Subject: [nsp] Serial0/0:0 is reset, line protocol is down.... ?


I have a 2600 with a VWIC-1MFT-G703 connected to a Telecom Italia
provided Selta SNT-H SHDSL access point (yep, E1 local loop over DSL ;)
).. The guy on site claims the config is as follows:

controller-type e1 0/0
channel-group 0 timeslots 1-31
framing nocrc


When doing a 'show controller e1' it says:

E0/0 is down
Receiver is getting AIS

Doing a 'show int' says:

Serial0/0:0 is reset, line protocol is down


Hard looping towards the router brings everything up.  Moving the coax
around results in a variety of loss of frame and loss of sync alarms and
the correct connections always result in AIS.  At this point I am fairly
well convinced that the problem is on the telco side and not some
configuration issue, but the provider had successfully tested through a
loop on this very equipment earlier in the day.

Any information would be most appreciated..

Thanks,
Tim

_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/