[nsp] dot1q on 2600 router

[CLAEREBOUDT Elke]

does anyone has a working setup for a connection between a catalyst 2948G
and a 2600 router, but on a 10M port, doing dot1Q encapsulation

CCO says it is supported from 12.2T on

<http://www.cisco.com/en/US/products/hw/routers/ps259/prod_bulletin09186a008
00921e4.html>

we run 12.2.15T but no success so far
all interfaces are up, but no traffic

config on router

 interface Ethernet0/0
>  description trunk
>  no ip address
>  no ip route-cache
>  no ip mroute-cache
>  full-duplex
>  no cdp enable
> !
> interface Ethernet0/0.1
>  description VlanDefault
>  encapsulation dot1Q 1 native
>  ip address 10.67.51.1 255.255.255.0
>  no ip route-cache
>  no ip mroute-cache
>  no cdp enable
> !
> interface Ethernet0/0.16
>  description xxx
>  encapsulation dot1Q 16
>  ip address 172.16.51.1 255.255.255.0
>  ip helper-address 172.16.80.11
>  ip helper-address 172.16.80.12
>  no ip route-cache
>  no ip mroute-cache
>  no cdp enable
> !
>

Elke 


*****DISCLAIMER*****

This electronic transmission (and any attached document) is intended 
exclusively for the person or entity to whom it is addressed and may 
contain confidential and/or privileged material. 
Any disclosure, copying, distribution or other action  based upon 
the information by persons or entities other than the intended recipient
is prohibited. If you receive this message in error, please contact the 
sender and delete the material from any and all computers. 
Mobistar does not warrant a proper and complete transmission of this
information, nor does it accept liability for any delays.

*****END OF DISCLAIMER*****