[nsp] dot1q on 2600 router

Voll, Scott Scott.Voll at wesd.org
Mon Mar 24 07:49:40 EST 2003

What's the config look like on the switch?

-----Original Message-----
From: CLAEREBOUDT Elke [mailto:ECLAEREB at mail.mobistar.be] 
Sent: Monday, March 24, 2003 7:49 AM
To: cisco-nsp at puck.nether.net
Subject: [nsp] dot1q on 2600 router

does anyone has a working setup for a connection between a catalyst
2948G and a 2600 router, but on a 10M port, doing dot1Q encapsulation

CCO says it is supported from 12.2T on


we run 12.2.15T but no success so far
all interfaces are up, but no traffic

config on router

 interface Ethernet0/0
>  description trunk
>  no ip address
>  no ip route-cache
>  no ip mroute-cache
>  full-duplex
>  no cdp enable
> !
> interface Ethernet0/0.1
>  description VlanDefault
>  encapsulation dot1Q 1 native
>  ip address
>  no ip route-cache
>  no ip mroute-cache
>  no cdp enable
> !
> interface Ethernet0/0.16
>  description xxx
>  encapsulation dot1Q 16
>  ip address
>  ip helper-address
>  ip helper-address
>  no ip route-cache
>  no ip mroute-cache
>  no cdp enable
> !



This electronic transmission (and any attached document) is intended 
exclusively for the person or entity to whom it is addressed and may 
contain confidential and/or privileged material. 
Any disclosure, copying, distribution or other action  based upon 
the information by persons or entities other than the intended recipient
is prohibited. If you receive this message in error, please contact the 
sender and delete the material from any and all computers. 
Mobistar does not warrant a proper and complete transmission of this
information, nor does it accept liability for any delays.


cisco-nsp mailing list  cisco-nsp at puck.nether.net
archive at http://puck.nether.net/pipermail/cisco-nsp/

More information about the cisco-nsp mailing list