[nsp] TokenRing stuck in 'reset' state

[kouji.baba at equant.com]

Hi,

Trouble occurs at TokenRing interface of NM-1E1R2W.

Its state goes into 'reset' after 'initializing'.
I have tried many 'clear interface token x/x', but not changed.
I have same NM on my lab (same IOS), but does not show 'reset' state.
I guess its firmware number will be strange '000000........'.
Lab equip has Board revision = D0 and trouble router has Board revision =
H0 by 'show diag'.

Is there anyone who had similar condition?
I want to know why the state does not become 'down' or 'up' after
initializing.

[show int]
pdur057#sh in to 0/0
TokenRing0/0 is reset, line protocol is down
  Hardware is IBM2692, address is 00d0.fad5.5441 (bia 00d0.fad5.5441)
  Internet address is 196.26.147.253/24
  MTU 4464 bytes, BW 10000000 Kbit, DLY 630 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation SNAP, loopback not set
  Keepalive set (10 sec)
  ARP type: SNAP, ARP Timeout 04:00:00
  Ring speed: 16 Mbps
  Duplex: half
  Mode: Classic token ring station
  Ethernet Transit OUI: 0x000000
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 3 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 transitions

[show controller]
Interface TokenRing0/0: state administratively down
  current address: 00d0.fad5.5441, burned in address: 00d0.fad5.5441

  Last Ring Status: none
    Stats: soft: 0/0, hard: 0/0, sig loss: 0/0
           tx beacon: 0/0, wire fault 0/0, recovery: 0/0
           only station: 0/0, remote removal: 0/0
  Interface failures: 0
  Monitor state: (not active), chip f/w: '000000........', [bridge capable]
    ring mode: 0
    internal functional: 00000000 (00000000), group: N/A (00000000)
    Internal controller counts:
      line errors: 0/0, internal errors: 0/0
      burst errors: 0/0, ari/fci errors: 0/0
      abort errors: 0/0, lost frame: 0/0
      copy errors: 0/0, rcvr congestion: 0/0
      token errors: 0/0
    Microcode TX errors:
      pci read 0/0, icdb read parity 0/0
      icdb write parity 0/0, icdb address parity 0/0
      status write 0/0, fifo underrun 0/0
      fifo parity 0/0, null particles 0/0
     Microcode RX errors:
      pci read parity 0/0, internal read parity 0/0
      internal write parity 0/0, internal address bfr parity 0/0
      fifo parity 0/0, no buffer 0/0
      pci write 0/0, fifo overrun 0/0
      receive parity error 0/0
      receive mpc error 0/0
      received implicit aborted frame 0/0, explicit aborted frame 0/0
      received giant mac frame 0/0
    Internal controller smt state:
      Adapter MAC:     0000.0000.0000, Physical drop:     00000000
      NAUN Address:    0000.0000.0000, NAUN drop:         00000000
      Last Source      0000.0000.0000, Last poll:         0000.0000.0000
      Last MVID:       0000,           Last attn code:    0000
      Txmit priority:  0000,           Auth Class:        0000
      Monitor Error:   0000,           Interface errors   0000
      Correlator:      0000,           Soft Error Timer:  0000
      Local Ring:      0000,           Ring Status:       0000
      Beacon rcv type: 0000,           Beacon txmit type: 0000
      Beacon type:     0000,           Beacon NAUN:       0000.0000.0000
      Beacon drop:     00000000,       Reserved:          0000
      Reserved2:       0000
    Ring sampling: 0/1000

[IOS version]
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3640-IS-M), Version 12.2(6c), RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sat 02-Feb-02 00:02 by pwade
Image text-base: 0x600089A8, data-base: 0x611A4000

ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)

pdur057 uptime is 3 hours, 2 minutes
System returned to ROM by power-on
System image file is "flash:c3640-is-mz.122-6c"

cisco 3640 (R4700) processor (revision 0x00) with 49152K/16384K bytes of
memory.
Processor board ID 29108059
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Basic Rate ISDN software, Version 1.1.
2 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
2 Token Ring/IEEE 802.5 interface(s)
1 Serial network interface(s)
4 ISDN Basic Rate interface(s)
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

[show diag]
Slot 0:
        Combo 1E, 1R, 2W Port adapter, 4 ports
        Port adapter is analyzed
        Port adapter insertion time unknown
        EEPROM contents at hardware discovery:
        Hardware revision 1.0           Board revision H0
        Serial number     29279984      Part number    800-01223-03
        Test history      0x0           RMA number     00-00-00
        EEPROM format version 1
        EEPROM contents (hex):
          0x20: 01 1F 01 00 01 BE C6 F0 50 04 C7 03 00 00 00 00
          0x30: 88 00 00 00 02 12 21 17 FF FF FF FF FF FF FF FF

-----
Kouji Baba (Equant)