[nsp] PA-T3+ in DCE mode supplying clock for PTP???

[Temkin, David]

Go for "clock source internal", instead of clock rate.  
(under the controller config for the modle)

-----Original Message-----
From: Scott Morris [mailto:swm at emanon.com] 
Sent: Monday, October 27, 2003 5:40 PM
To: cisco-nsp at puck.nether.net
Subject: [nsp] PA-T3+ in DCE mode supplying clock for PTP???


According to the docs I can use the clock rate command to supply clock to
the other end of the link.  However, the router won't let me...  Is there
another command I'm unaware of in order to do this!?!?!  I appear to be
getting slippage on the DS3 line as if both sides are using different
clocks.
 
Thanks in advance!
 
 
Scott Morris, MCSE, CCDP, CCIE4 (R&S/ISP-Dial/Security/Service Provider)
#4713, CCNA-WAN Switching, CCSP, Cable Communications Specialist, IP
Telephony Support Specialist, IP Telephony Design Specialist, CISSP, JNCIS,
INFOSEC CCSI #21903 swm at emanon.com
 
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/