[c-nsp] Catalyst interface problem - 2924

[Paul Stewart]

We have a Cisco 2924M-XL-EN at a remote site... all the interfaces are
clean on the switch except one that is our "backhaul" to our main
office.

The errors keep climbing.  Cables have been swapped, IOS changed, and
transport equipment (Nortel Optera) been checked over... so far nothing
has been found as to why this is happening.  At the other end of the
link is Nortel Optera transport equipment which then connects back to a
Catalyst 6509 on our side.  On our side the link is clean with ZERO
errors etc...

Are we pushing this little 2924 too much?

Thanks,

Paul

FastEthernet0/1 is up, line protocol is up
  Hardware is Fast Ethernet, address is 0001.42f0.0b81 (bia
0001.42f0.0b81)
  Description: WAN-Millbrook-Link
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 58/255, rxload 87/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s, 100BaseTX/FX
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:04, output 00:00:00, output hang never
  Last clearing of "show interface" counters 4d12h
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 34373000 bits/sec, 10020 packets/sec
  5 minute output rate 22989000 bits/sec, 8203 packets/sec
     2764432649 packets input, 2332296557 bytes
     Received 2141100 broadcasts, 0 runts, 0 giants, 0 throttles
     60546 input errors, 60546 CRC, 0 frame, 1936 overrun, 1936 ignored
     0 watchdog, 138087 multicast
     0 input packets with dribble condition detected
     2302489412 packets output, 3082367651 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out