[c-nsp] Radius & vrf attributes

[M.Palis]

Hello all..

 I am trying to configure Radius to send ip route /vrf to the user as below.

Cisco-AVpair = "ip:route = vrf test 0.0.0.0 0.0.0.0 10.10.1.254"

Radius accept the above but when I do show ip route on the router, it seems
that the route is not inserted in the routing table. Any help will be
appreciated. Below is the radius config for the users



test Auth-Type := MS-CHAP, Password == "!test"
        Service-Type = Framed-User,
        Framed-Protocol = PPP,
        Cisco-AVPair = "lcp:interface-config=ip vrf forwarding test \n peer
default ip address pool test \n ip unnumbered loopback3",

    Cisco-AVpair = "ip:route = vrf test 0.0.0.0 0.0.0.0 10.10.1.254"