[c-nsp] Radius & vrf attributes

[M.Palis]

It is not working.. It is very strange actually. Radius accepts the command
and it starts normally but IP route does not shown in the vrf routing table
of the router.

Are you using the command?
----- Original Message ----- 
From: "Dennis Peng" <dpeng at cisco.com>
To: "M.Palis" <security at cytanet.com.cy>
Cc: <cisco-nsp at puck.nether.net>
Sent: Friday, December 03, 2004 6:39 PM
Subject: Re: [c-nsp] Radius & vrf attributes


> M.Palis [security at cytanet.com.cy] wrote:
> > Hello all..
> >
> >  I am trying to configure Radius to send ip route /vrf to the user as
below.
> >
> > Cisco-AVpair = "ip:route = vrf test 0.0.0.0 0.0.0.0 10.10.1.254"
>                           ^ ^
>                           | |
>                           +-+--- remove these spaces.
>
> And try again please.
>
> Dennis
>
> > Radius accept the above but when I do show ip route on the router, it
seems
> > that the route is not inserted in the routing table. Any help will be
> > appreciated. Below is the radius config for the users
> >
> >
> >
> > test Auth-Type := MS-CHAP, Password == "!test"
> >         Service-Type = Framed-User,
> >         Framed-Protocol = PPP,
> >         Cisco-AVPair = "lcp:interface-config=ip vrf forwarding test \n
peer
> > default ip address pool test \n ip unnumbered loopback3",
> >
> >     Cisco-AVpair = "ip:route = vrf test 0.0.0.0 0.0.0.0 10.10.1.254"
> >
> >
> >
> >
> > _______________________________________________
> > cisco-nsp mailing list  cisco-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-nsp
> > archive at http://puck.nether.net/pipermail/cisco-nsp/