[c-nsp] 12.2 -> 12.2S upgrade and PA-2T3+ problem

[Rodney Dunn]

Brian,

If you loop the T3 coax does it come up?

Rodney

On Tue, Dec 07, 2004 at 01:45:34AM -0600, Brian Feeny wrote:
> 
> 	
> Tonight I upgraded a router that was running c7200-p-mz.122-26.bin to 
> c7200-k91p-mz.122-25.S1.bin.
> Before the upgrade one of its Serials was working fine, afterwards, its 
> down/down.  The serial is a port
> on a PA-T3+.  The other port is working fine.  I diffed the configs, 
> and there were no changes that would cause operational problems.
> 
> I tried to reset the interface and still no go.  Its not a critical 
> interface, so I havent reverted back to 12.2 just yet, I am going to 
> try to figure out what happened here.  I did check "sh ip bgp sum" 
> right before the reload after the code change, and that interface was 
> definitely working.  Has anyone seen anything like this on 12.2S?
> 
> Brian
> 
> ---------------------------------------------
> Brian Feeny, CCIE #8036, CISSP
> Network Engineer
> ShreveNet Inc.
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/