[nsp] OSPF over RBE - no full adjacency

[Bruce Pinsky]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Vincent De Keyzer wrote:

| Hello people,
|
| how do I make the following two boxes establish an OSPF adjacency?
|
| It seems that simple network statements are not enough - neighbors remain in
| Exstart/Exchange phase.
|
| Vincent
|
| _________________________________________________________________
|
| Router A:
|
| interface ATM2/0.12801 point-to-point
|  description To Router B
|  ip address x.y.240.81 255.255.255.252
|  ip verify unicast reverse-path
|  atm route-bridged ip
|  pvc RouterB 12/801
|   vbr-nrt 2000 2000
|   encapsulation aal5snap
|  !



Have you tried the "ip ospf network non-broadcast" command yet?

|  ntp broadcast
|
| alfonso#sh ip o ne
|
| Neighbor ID     Pri   State           Dead Time   Address         Interface
| RouterB           1   EXCHANGE/  -    00:00:37    x.y.240.82   ATM2/0.12801
|
|
|
| Router B:
|
| interface Ethernet0/0
|  description To Router A
|  ip address x.y.240.82 255.255.255.252
|  ip verify unicast reverse-path
|  load-interval 30
|  full-duplex
|  ntp broadcast client
|
|
| RouterB#sh ip o ne
|
| Neighbor ID     Pri   State           Dead Time   Address         Interface
| RouterA           1   EXSTART/BDR     00:00:39    x.y.240.81   Ethernet0/0
| blanche15#
|
|
| _______________________________________________
| cisco-nsp mailing list  cisco-nsp at puck.nether.net
| https://puck.nether.net/mailman/listinfo/cisco-nsp
| archive at http://puck.nether.net/pipermail/cisco-nsp/


- --
=========
bep

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (MingW32)

iD8DBQFADsg5E1XcgMgrtyYRAtCoAJ4tC1OhEyJPCFmGVzPJ2xTfLpQtZQCg8kck
5Z7jZ+rfmHDxtWaJ5fBZ578=
=iUt5
-----END PGP SIGNATURE-----