[nsp] translation-rule in 12.3 ?

Mikhail Assiaev misha at csi.ru
Thu Jul 8 06:51:25 EDT 2004


Hi,

I have noticed that translation-rule is not working in 12.3 on 5300/5350
platform if the calling party number is empty.

The translation rule I am using is very simple (I'm trying to add a valid
CPN for a customer who is using equipment not capable to send CPN) :
!
translation-rule 1
 Rule 0 . 999
!
dial-peer voice 1 pots
 huntstop
 destination-pattern 345#
 progress_ind setup enable 3
 progress_ind progress enable 8
 translate-outgoing calling 1
 direct-inward-dial
 port 0:D
!

If the remote gateway sends at least 1 digit as CPN, translation rule works
fine. If CPN is empty, the call is forwarded to PBX with the empty CPN
field.
This configuration was working on 12.2 for a long time with no problems,
translating the empty CPN to a valid CPN before sending to PBX...

Has anyone seen the same behaviour in 12.3 ? Or maybe there is a better
solution to add CPN before forwarding a call to PBX ?

Thanks in advance.
WBR, Misha



More information about the cisco-nsp mailing list