[nsp] Transparent bridging over E1 WAN link

Fernando Catalão fernando.catalao at broadnet.pt
Mon Jul 19 06:41:38 EDT 2004


Hi,

We have a circuit (E1) connecting our two sites.
Besides routing (using EIGRP), which is already in place between the two sites, we are trying to bridge an ethernet port in site #1 to another ethernet port in site #2.


TOPOLOGY
                                     
                           -------------
                          |  3524  |
                           -------------
	                    |
		        |  SITE 1
                           -------------
                          |  7206  |
                           -------------
                                |
                                |
                                |
                                |E1
                                | 
                                |
                                |  SITE 2
                           -------------
                          |  7206  |
                           -------------
	                    |
     		        |
                             --------------
                             | 3524   |
                             --------------


I have tried this example but to no avail. I am trying to bridge sub-interface 20 site 1 to sub-interface 10 site 2.


----------7206 site 1------------
bridge 10 irb
bridge 10 protocol ieee
bridge 10 route ip
 
int fe0/0.10
  bridge 10 

int s0/0
  ip add t.t.t.1
  bridge 10
----------------------------------


----------7206 site 2------------
bridge 10 irb
bridge 10 protocol ieee
bridge 10 route ip
 
int e0/0.10
  bridge 10 

int s0/0
  ip add t.t.t.2
  bridge 10
----------------------------------

Any help would be greatful.

Regards

Fernbando


More information about the cisco-nsp mailing list